Why galvanised steel peels

Galvanised steel is steel coated in zinc to slow rusting. Hot-dip galvanised structures, pre-galvanised sheeting, palisade fencing and gates are all galvanised. Primers made for bare steel, such as red oxide or FPW15, don't bond to zinc, so the paint lifts off in sheets.

Zinc also reacts with air to form white rust, a powdery zinc hydroxide carbonate. Paint applied over it bonds to the powder, not the metal.

1. Prepare the surface

New galvanised steel:

  1. Remove dust, dirt and oil.
  2. Wash with a galvanised iron cleaner or sugar soap solution. Armourphos Cleaner is a phosphate-based cleaner for metal, galvanised iron and aluminium.
  3. Rinse thoroughly with clean water.
  4. Let it dry completely. Moisture trapped under the primer stops it bonding.

Weathered galvanised steel develops a chalky layer. Sand it lightly to remove the chalk, then clean, rinse and dry as above. Paint only when the steel is at least 3 °C above the dew point.

2. Choose the primer

Galvanised Iron PrimerEPS15 etch primer
What it isLead-free, medium build primer for galvanised iron and zinc-coated steelSelf-etching, fast drying primer for galvanised, aluminium and bare metal
Dry film thickness50–60 µm10–15 µm
Touch dry± 2 h± 10 min
OvercoatOvernightAfter at least 1 h
ThinningNot recommended; at most 5% FD Thinner if neededEtch thinner; at most 15% if needed (not for airless spray)
Packs listed5L25L

Galvanised Iron Primer builds a thicker film in one coat, which suits fencing, gates and structures. EPS15 is the faster option when the topcoat has to follow within the hour, but it builds a much thinner film.

Brush and roller are fine for Galvanised Iron Primer up to 100 µm wet film thickness (WFT) per coat; airless spray is preferred for large areas.

3. Topcoat

Both primers take an enamel topcoat. Fast Dry Enamel lists etch primer as a suitable undercoat on its datasheet and comes in SANS and RAL colours.

Let Galvanised Iron Primer stand overnight before topcoating. For roofs, follow the roof sheeting guide, because roof sheeting has its own topcoat advice.

4. Measure the film correctly

A magnetic dry film thickness (DFT) gauge reads the zinc and the paint together. Measure the bare galvanised steel first and subtract that reading, or the paint will look thicker than it is. The film thickness measurement guide covers gauges and readings.

Mistakes that cause peeling

  • Red oxide, FPW15 or another bare-steel primer straight onto zinc.
  • Painting over white rust or the chalky layer on weathered galvanising.
  • Topcoating Galvanised Iron Primer the same day.
  • Thinning Galvanised Iron Primer by more than 5%.

For steel, aluminium and concrete as well, see the surface preparation guide. To order, request a quote with the area, the condition of the zinc and your colour.