Why IBR needs its own primer

IBR (inverted box rib) sheeting is galvanised steel: steel coated in zinc to slow rusting. Primers made for bare steel, such as red oxide or FPW15, don't bond to zinc and will peel. Use GI Primer, made for galvanised surfaces.

1. Prepare the surface

New, unpainted IBRPreviously painted IBR
Remove dust and dirtScrape or wire-brush off flaking paint and rust, only where it is failing
Wash with galvanised iron cleaner or sugar soapWash the whole roof with sugar soap (a broom helps on large roofs)
Rinse with clean waterRinse with clean water
Let it dry completelyLet it dry completely

Moisture trapped under the primer stops it bonding. For galvanised steel other than roofs, see how to paint galvanised steel.

2. Prime

  • New IBR: a full coat of GI Primer over the whole surface.
  • Previously painted IBR: spot-prime the bare metal exposed by scraping.
  • Apply by roller, roof brush or spray.
  • GI Primer is touch-dry in about 2 hours and overcoated the next day (from its technical data sheet).

3. Topcoat

Our IBR guide recommends a water-based or solvent-based acrylic, or a specialist roof paint. Follow that product's TDS for the number of coats and drying times. Ask us which suits your roof.

Tips for a good finish

  • Don't paint in direct sun or high wind. Fast drying gives an uneven film.
  • Keep a wet edge, working in sections, to avoid lap marks.
  • Work from the ridge down towards the gutters.
  • Let each coat dry fully. Painting over a wet coat traps solvent and causes blisters.

Step-by-step detail is in our IBR sheeting guide.